Canoga-perkins CanogaOS Configuration Guide Uživatelský manuál stáhnout pdf (Strana 316)

CanogaOS Configuration Guide

Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 316 of 350

DUT(config-if)# no switchport Configure the port as layer3 routed port

DUT(config-if)# ip address

202.38.100.1/24

Set the IP address for the routed port

Configuring the Switch-to-RADIUS-Server Communication

RADIUS security servers are identified by their host name or IP address, host name and specific

UDP port numbers, or IP address and specific UDP port numbers. The combination of the IP

address and UDP port number creates a unique identifier, which enables RADIUS requests to be

sent to multiple UDP ports on a server at the same IP address. If two different host entries on the

same RADIUS server are configured for the same service—for example, authentication—the

second host entry configured acts as the fail-over backup to the first one. The RADIUS host

entries are tried in the order that they were configured. In this release, up to 3 RADIUS server

can be configured.

DUT# configure terminal Enter the Configure mode.

DUT(config)#radius-server host

202.38.100.7 key test retransmit 3

timeout 5 auth-port 1812

Configure the RADIUS server parameters on the switch.

The key is a text string that must match the encryption key used

on the RADIUS server.

If you want to use multiple RADIUS servers, re-enter this command.

DUT(config)# radius-server deadtime 5 Specify the server active period, the default is 5 minutes.

1 2 ... 311 312 313 314 315 316 317 318 319 320 321 ... 349 350

Žádné komentáře

Canoga-perkins CanogaOS Configuration Guide Uživatelský manuál Strana 316