Canoga-perkins 9145E Network Interface Device Uživatelský manuál stáhnout pdf (Strana 22)

9145E Ethernet Network Interface Device User’s Manual Functional Description

Port Default Settings

2.5 Port Default Settings

Table 2-2 represents the default settings for each of the ports. The term active connector refers to

the connector, either UTP or SFP, that is currently enabled. For example, if a particular 9145E

model has a User Port with both UTP and SFP connectors present, by default the UTP is the

Active Connector (it can currently transmit and receive data), while the SFP is the Inactive Con-

nector (i.e., it currently cannot transmit or receive data).

Table 2-3. Default Port Settings

NOTE:Cells in yellow denote which of the connectors are active by default

2.6 Power Connectors

The normal version of the 9145E will accommodate both single and redundant AC and DC pow-

ering options, along with mixed AC and DC power, while the hardened version is limited to DC

power only.

2.6.1 Power Requirements

100 VAC to 240 VAC (auto-ranging), 50 to 60 Hz, 0.5 Amps (9145E only)

36 VDC to 72 VDC, 1.0 Amps (Both 9145E and hardened 9145E)

18 VDC to 36 VDC, 2.0 Amps (Hardened 9145E only)

2.6.2 Single AC Power Base Unit

The Single AC powered 9145E base unit (see Figure 2-4) has an IEC 320 power connector on

the rear panel. An appropriate AC power cord is supplied with the unit.

Figure 2-4. Single AC Power

UTP

SFP w/ 100

Mbps Optics

SFP w/ 1000 Mbps

Optics

SFP w/ Multispeed

Optics (100 to 1000)

User Port Auto 100 FD 1000 FD 1000 FD

Network Port Auto

100 FD 1000 FD 1000 FD

Multipurpose Port Auto

100 FD 1000 FD 1000 FD

Mgmt UTP port

Auto N/A N/A N/A

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Žádné komentáře

Canoga-perkins 9145E Network Interface Device Uživatelský manuál Strana 22