Canoga-perkins 9145E Ethernet Network Interface Device Hardware Uživatelský manuál stáhnout pdf (Strana 14)

9145E Ethernet Network Interface Device User’s Manual Introduction

9145E Specifications

1.2 9145E Specifications

1.2.1 Physical Characteristics

Dimensions: 1.75" H x 8.25" W x 11.5" D (44.5 x 209.5 x 292 mm)

Weight: 6.5 lb (2.95 Kg)

1.2.2 Environmental Characteristics

Operating Temperature: 0° to 50° C

Operating Humidity: 90% (non-condensing)

1.2.3 Power Requirements

100 VAC to 240 VAC (auto-ranging), 50/60 Hz, 0.5 Amps

36 VDC to 72 VDC, 1.0 Amps

1.2.4 Regulatory Compliance

• EN60825-1 (Laser Safety)

•CE Mark

• EMC Directive (EN55022 Class A, EN 55024, EN 61000-3-2/-3-3)

• ETL, cETL & LVD (U.S. UL60950, CAN/CSA C22.2 No. 60950, EN/IEC 60950)

• FCC Part 15B Class A (U.S.), ICES-003 (CAN), VCCI Class A (Japan), C-Tick

(AS/NZS 3548 - Australia)

• NEBS Level 3 Certified & Tested

1.3 Mounting Requirements

The 9145E can be rack mounted (as a single unit or as two units side-by-side), wall mounted with

the front panel facing the floor, facing to the right, or facing to the left, or set on a desk, table or

shelf as a stand-alone unit. Reference Chapter 3, Installation, for 9145E installation procedures.

1.3.1 Rack Mounting

Canoga Perkins includes the mounting brackets required (see Figure 1-2) to allow the unit to be

mounted in a 19" or 23" rack.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

Žádné komentáře

Canoga-perkins 9145E Ethernet Network Interface Device Hardware Uživatelský manuál Strana 14